How to request a port for Votifier or Dynmap

Go to the Additional Ports menu, by clicking either of the boxed options on your server's panel page How to get to additional ports

Click Add Port on the left Add Port

The table will show your new port number, in this example my port would be 8178 Port 8178

You can repeat this in order to get a maximum of 3 additional ports

Configure your plugin to use the port number in it's config file. If the plugin asks for an IP address to bind to, this would be 0.0.0.0, not your server's IP. Then, the port will be accessible through your server's IP, for example if your server IP is 12.34.56.78:25578 and Dynmap is running on port 8178 then you can access it by going to http://12.34.56.78:8178 in your browser.

IPWhitelist

Usually, IPWhitelist should configure itself automatically when you first join the server, however if this isn't working for you then you can try setting it up manually:
Firstly, on your Hub server, run the command ipwl debug.
Once you've ran that, join the Bungeecord IP and check the console of your Hub server, you should see a message similar to the following: [Server] INFO [IPWhitelist] Player PebbleHost is connecting with IP : /192.168.0.1
Once you've got that go ahead and run the following command on all your servers behind Bungeecord (for example your Factions, Skyblock, etc servers): ipwl addip <ip>. For example, since the connecting IP is 192.168.0.1 in the example above, you would run ipwl addip 192.168.0.1
Was this article helpful?
Cancel
Thank you!